6061-T6 Aluminum Flange Disc with Lightening Cutouts 1200mm OD for Rotary Table Aluminum Rotary Plate
large diameter aluminum flange disc
,lightening cutout rotary plate
,6061-T6 machined disc 1200mm
A large-diameter aluminum flange disc machined from 6061-T6 plate, turned on both faces and milled with lightening cutouts to reduce rotating mass without weakening the hub area. The disc is delivered with a defined bolt circle, central bore, and balancing slots so it can be mounted directly onto a rotary table or indexing head. Every disc is checked for flatness, bore concentricity, and hole position before packing.
Working outer diameter ranges from 200 mm to 1200 mm, plate thickness from 10 mm to 50 mm, and the hole pattern is fully defined by the customer drawing.
- 6061-T6 plate stock — stable grain structure, good machinability, and uniform anodizing colour across large surfaces.
- Lightening cutout strategy — pockets and arc slots are placed outside the load path, reducing inertia while keeping hub stiffness.
- Single set-up turning — both faces machined in one clamping to hold parallelism and avoid wedge-shaped discs.
- Bolt circle accuracy — hole positions generated from one datum, so mating components index without reaming on site.
| Material | 6061-T6 aluminum plate (7075 on request) |
|---|---|
| Outer diameter | 200 mm – 1200 mm |
| Plate thickness | 10 mm – 50 mm |
| Central bore | 20 mm – 300 mm, H7 available |
| General tolerance | ±0.02 mm |
| Flatness | 0.03 mm over full face |
| Surface | As machined, sandblasted, clear or black anodized |
Plate sawing, stress relief, rough turning, finish turning of both faces, CNC milling of cutouts and bolt holes, deburring, surface treatment, then dimensional verification. For discs above 800 mm, we machine with temporary support ribs and remove them at the final pass to avoid chatter marks.
- CMM check of bolt circle, bore position, and cutout profile
- Flatness and thickness measured at four quadrants
- Concentricity of bore to outer diameter verified on the rotary fixture
- Photo and inspection record available with each batch
Rotary tables, positioning heads, conveyor turntables, camera motion platforms, printing register discs, and general automation frames.
Each disc is wrapped in PE film, cushioned with foam, and supported vertically inside a plywood case to prevent bending during transport. Express, air, and sea freight are all arranged according to schedule.
Yes. Slot width, arc length, and pocket depth are adjusted to your drawing, as long as the hub and bolt circle remain intact.
Fasteners are not part of the standard scope, but we can source them and ship as a kit if requested.
A vertical plywood frame with foam pads and a rigid centre support is used, and the case is marked as keep-flat cargo.
-
MFor a shop that goes through a few of these a quarter, the savings add up. Reordering now.
-
SKlarer Kaufgrund: Preis-Leistung stimmt. Kleiner Hinweis: Die englische Produktbeschreibung ist knapp, aber die technische Zeichnung auf Anfrage war vollständig. Gerne wieder.
-
EProbably an unusual use case: I needed a modern, clean-looking bearing housing for a rotating art piece going into a lobby installation. Most off-the-shelf bearing blocks are cast iron or painted steel and look clunky. This aluminum post with the triangular flange and brushed finish fits the aesthetic I wanted. Machining quality held up, no visible tool marks, edges clean. The artist client didn't even realize it was a "made for machines" part.
Send your inquiry directly to us